The working MASTER injection mold maker principle of injection mold

The working principle of mold temperature machine consists of a water tank, heating and cooling system, power transmission system, the liquid level control system and a temperature sensor, injection port devices. Usually, power transmission system in the pump so that the thermal fluid from the tank is equipped with a built-in heater and MASTER injection mold maker cooler to die, then die from the back to the water tank; temperature sensor to measure the temperature of hydrothermal fluids and transmit data to the control part of the controller; the controller adjusts the hydrothermal temperature, thereby indirectly control the mould temperature. MASTER molds for plasterIf the mold temperature machine in production, mold temperature exceeds the set point of the controller, the controller will open the electromagnetic valve is communicated with a water inlet pipe, until the heat fluid temperature, the mold temperature to the set point. If the mold temperature is lower than the set value, the controller will turn on the heater.